View Full Version : Drivetrain
- Fly wheel selection
- c-4 question
- 15x10.5
- drive shaft
- rear gear choice, help needed
- Converting from a aod to a c-4
- SFI Bellhousing
- Jerico Or Powerglide
- Cyn-R-Gy or Fidanza alum flywheel??
- o3 cobra motor to AOD Questions
- what is the correct way to powershift?
- 5 lug rotors
- bolt size
- WTB: FMS M-4602G driveshaft
- Getting Ready to Do Gears, have question
- Moser Are What!
- low mile t5
- moser 35 spline,gun drilled, 4 lug axles for sale
- Rear Wheel To Quarter
- Gun Drilled Axles and Street Use?
- PA supercomp c4 converter and shifter
- 4cly brake booster on an 8cly car??
- torque converter?
- BackLash...
- What Clutch Would You Run
- Brakes?
- Transmission Problem
- Powergilde Crossmember
- moly vs. steel driveshafts
- wilwood rear disc *help*
- Anyone here run or heard of JW trannys?
- Converter expert, I need help...
- Need c4 to handle 650 hp
- Putting a 4cyl Brake Master Cylinder on an 8cyl car??
- aode stand alone controler?
- Which tranny to go with?
- Dynamic or Pro-formance Transmissions
- mini tubs
- 4 lug wheel question
- AJE powerglide x-member
- LSD - Eaton vs Detroit Truetrac
- 2-speed vs 3-speed
- Who sells a 66-69 C-4 transmission
- Complete MOSER 33 Spline Full Spool Rear End $600.00
- What trans cooler to go with?
- C-4 to 8.8 rear driveshaft
- Tko 3550
- Need help picking stall converter
- Anyone using the Detroit Truetrac?
- oil pan clearance
- AFM clutch
- noises in drivetrain
- TH-400 in a 95
- need some advice
- 2-3 flare in a C-4
- SN-95 axles
- Transmission dowel pins
- C4 Power Levels?
- I have my dowel pins, now how do I get them into the block?
- Brakes
- Windsor 351 + powerglide users - I need help
- Neutral safety switch wiring
- Stock V8 Brakes and no booster
- need help identifying this conv.
- Please Help Me!!! Lentech Question
- driveshaft questions...
- how to fit sn-95 spindles on a fox ?
- Converter help!!!! new to Auto's
- aerosapce ?
- manual brake ?
- Bleeding Brakes
- what flywheel?
- who makes a rear 5 lug setup for c clip eliminators
- bellhousing??
- Spragless Converters
- 9" and 8.8" Question
- Will A C6 Fit A 93lx
- gear ratio?
- Wheel Spacers ?
- need Lenny/former TCT phone #
- C4 shift kit
- I bet you have NEVER heard this one!!
- Hurst roll control unit on a 95 GT
- mark 7/ t-5 question
- mini tubs
- What exactly needed and how hard is t-5 to AOD swap
- yoke coming out of trans?
- C4 speedo gear
- rear end robbing horsepower
- Has anyone heard of or used Alloy USA axles.
- Looking for stock 2005-06 Mustang rear control arms
- 12" rim?????
- SBf Glide to 8.8 questions
- SHIFTER FOR 2005-2006.-what do you use?
- hurst quarterstick
- who makes a nice c-4 that will hold 700 to 850hp
- converter help
- c4 fittings
- Fast C4 or Powerglide
- 98 Cobra complete rear end
- HELP: 9" Center & Axles Moser or Strange?
- Jhon Deere Hy-guard For Trans Fulid
- Full roller c-4!!!!
- 93 mustang lx c6 swap
- th 400 to fox body cross member
- need trans builder
- C-4 Shifting
- Lo 10 sec 60 foots
- Width of stock rearend?
- Street racing!?!?!
- Aode Shifting Question
- what gears to use???
- trans lines
- C4 C5 bellhousing NEED HELP FAST
- launching off a two step or on the converter?
- Need advice on Gear Noise
- Moser vs Strange!!! need opinions ASAP
- Gears
- glide input shaft question
- C4 tranny backs up hard
- rear disc brakes
- C4 or C6 Transmission
- question for converter guys!!
- Gear ratio ?
- How many passes?
- Installing spool/axles need help
- stick vs automatic
- rear axle ?
- Show me your front brake line setups with aftermarket brakes
- C-Clip Eliminators?
- C4 Planetary
- how long have ur stock 8.8 axles last b4
- tight convertor??
- Powerglide feed line
- Trans. brake?????????
- Line lock
- Hurst Quarter Stick in 2002 GT
- powerglide reverse clutch pack
- Gear ratios
- thoughts on transmissions
- opinions on IRS rears on fox body
- any one herd of redneck performance??
- header clearance with PG
- powerglide in 92 coupe
- hy-guard in c4
- motorsport drive shaft U JOINT question
- What gears
- Gear Help ?
- AOD detent adjustment
- is a power glide needed
- ARRG I'm Lost again.
- Need Help , Which Aod should I get?
- G-Force trans
- tire + gear question?
- G-Force or Jerico????
- speedo question
- steering problem need info?
- Leather shifter boots
- Vibration in drive train.....HELP please
- what gear
- Manual brake conversion help please.
- 9" axle and housing question
- Powerglide shifter / fox body question
- Pilot bearing in a Eagle crank???
- Which # is the SFI # on a J.W. Powerglide bellhousing?
- what trans
- Help on Convertor for 306/ nitrous
- need torque spec for C-6 ext housing bolts
- 8.8 axle ???
- Dynamic Trans Or Proformance
- AODE Part Needed ASAP!
- Which C4
- driveshaft length
- Does anyone have a 4 wire Lentech AOD
- putting in a powerglide any help
- c4 help needed!!!
- 8.8 axle ?
- Lenny@ Ultimate Converter Concepts goes above the call of duty! Thank you!
- 8.8 or 9"?
- Clutch suggestions
- what axles studs are legal????
- powerglide question
- t-5 to c-4 conversion
- Dynamic Converter (Frank Lupo)
- Running out of Gear at top end....tire/gear??
- 9 sec AOD or 4R70W ?............
- AOD advice
- AOD or AODE
- glide vs c-4
- Ultimate converters
- JPT Transmissions in Mich.
- trans or converter blew?
- mustang rear end lengths??
- stock glide case
- Need new glide any recs...
- Front BS
- Reverse manual valve body
- JPT Transmissions, in Mich.
- glide to 4.6
- glide or c4
- Limits of the 8.8
- Turbo spool up with variable stall control
- 9s on pumpgas on motor
- 8.8 or 9''
- Mark Williams says no to re-spline axles
- c4 vs. glide on drag radials
- Spool or Posi for 8.8
- Anyone here run Aerospace Manual brake master cyl? need help
- C-4 Brake?
- u joint question
- 8.8 vs 9 inch
- New Fresh T-5 Cheap!!!
- Powerglide Experts...Come On In
- Take off S-197 8.8 rear assemblies
- 5spd proshifted/faceplated users inside please
- Tremec Help
- motor mount question
- glide question
- Glide help????
- Axle welding
- tremec
- Glide Question, mini starter
- Brake rotor grinding question
- What will a Trac-loc take for abuse
- big problem with dynamic c4 ( delaware)
- which 1350 u-joint?
- TURBO 400 VS GLIDE (not again)
- Flywheel/Clutch questions...
- powerglide and hooker headers?
- Trans for 289 & 347??????
- Mid Plate Help
- shifter help !
- glide in fox body question
- McLeod Softlock clutch, Anyone??
- tremec 3550/tko users?
- c4 conversion
- aod or faceplated tko
- Glide Question
- Need my headers coated
- c4 trans fluid problems ?
- Looking for gear ratio suggestions...
- AOD trans shield
- sn95 C4 shifter mounting options?
- trans question need help asap
- Best Converter ??
- AOD Strength
- T-5 to C4 tranny questions. HELP!!!!
- What clutch?
- Question for the dual rear caliper folks
- '90 Axles Fit in '94 ??
vBulletin® v3.8.4, Copyright ©2000-2010, Jelsoft Enterprises Ltd.