Spherical Bushing - Upper Control Arms

[Jacsracing]

I'm in the process of installing a new 9" Rear to replace the 8.8. I picked up a set of those spherical bushings for the upper control arm mounts. However, looking at them, they seem kinda flimsy. Can these things take the abuse of a high horsepower car?

Thanks

John

[wickedrenegade]

yes they can take the abuse.....are they made for the 9 inch? moser housing? we have em on my renegade car without any problems..........just make sure they are a tight fit when u instal em so they dont move at all........we usually use a dremel to clean up the bores then make sure its snug....but not too snug.......use a block of wood and whack em in.......make sure they rotate freely after.......then u are good to go........kevin @ wicked