Glenn Amos
06-20-2005, 07:48 AM
This was the short block that was going into the shop car, and we have decided to go with a big inch windsor instead, so now all parts are being sold for far less than new prices. All parts are brand new, and ready to go.
CP Pistons +.020 Dome fly-cut for 4V
GRP Aluminum Rods with Honda Big Ends
Cobra Steel Crankshaft Offset Ground, turned to Honda Rod Journal sizes. Rod and Main Journals have been Hard Chromed. 5 Slugs of Mallory This is a very expensive piece to duplicate!
Federal Mogul Main Bearings
Clevite Rod Bearings
Total Seal ringset
Internally balanced
New, this would cost over 3700 to duplicate.
Asking $2500.
Pro Machined 4.6 Aluminum Block
Bored
Finish Honed to Above Pistons and Crank
Decked
ARP Main Studs
Ready to go!
Would cost $1100 to buy, asking $875
Will turn into a short block for an extra charge.
Feel free to PM me, or call the Shop to talk further about it.
Thanks
Glenn
Fox Lake
330 682 8800
CP Pistons +.020 Dome fly-cut for 4V
GRP Aluminum Rods with Honda Big Ends
Cobra Steel Crankshaft Offset Ground, turned to Honda Rod Journal sizes. Rod and Main Journals have been Hard Chromed. 5 Slugs of Mallory This is a very expensive piece to duplicate!
Federal Mogul Main Bearings
Clevite Rod Bearings
Total Seal ringset
Internally balanced
New, this would cost over 3700 to duplicate.
Asking $2500.
Pro Machined 4.6 Aluminum Block
Bored
Finish Honed to Above Pistons and Crank
Decked
ARP Main Studs
Ready to go!
Would cost $1100 to buy, asking $875
Will turn into a short block for an extra charge.
Feel free to PM me, or call the Shop to talk further about it.
Thanks
Glenn
Fox Lake
330 682 8800