c-clip eliminator install help

[5.0Slut]

I got my new moser 33spline axle kit but no instructions came for the eliminators how do you install them

[Stangfireman]

I'd suggest calling Moser and asking. But if I remember correctly, you cut the bearing housing, (lip sticking out of the housing) and leave 1/4 inch I think. Not exactly sure on this length. Make sure it is as straight as you can get it. I used a sawzall, cut it a little big and a grinder to get it square to length. Deburr it and when you go to install the axles, make sure you have plenty of sealant. Don't be skimpy with it. I seriously covered mine. Never had a leak. Although I did something that I had to pull the axles again and I didn't get enough on and it leaked before I even sat the car on the ground. If you run out of what they sent you, you can also use the blue permatex. I'm sure the other colors would work also. You can't get too much on the end.
Good luck!

[TED LONG]

I used strange , instructions said to cut ends flush with flange you bolt them to. Use a tool to pull out bearing.

[RICH JELINEK]

I run Moser stuff, leaving a 1/4" of tube outside of the housing end sounds about right (been a while since I did mine) - but I would call Moser just to make sure. As far as sealant goes - the stuff Moser sends with the elims. is actually the same as Permatex Ultra Grey, which is what I use and never have had a problem.

GOOD LUCK,
RICH