PDA

View Full Version : UPR pro series help?

conbread
04-09-2006, 06:34 PM
my car had south side uppers and lowers and with 325-50-15s the car had 3-4inches between tire and top fender.Now i put the upr adj on upper and lowers and the fender sat on the tire.I measured center to center on south sides and made the uprs the same. what can i do to get the car to sit like it was. thanks for any help conbread
p302stang
04-09-2006, 06:38 PM
you need to measure off a stock arm not the south side. the south side bars aren't the same length as a stocker and they have the bracket that relocates the mounting point. using them as a refernce is going to make everything out of whack.
conbread
04-09-2006, 06:56 PM
thanks for the help. TTT
saleen_n_around
04-09-2006, 07:12 PM
Also, are the southside brackets still welded to the rear or were they just bolted in? All Southside brackets have to go, use the stock holes on the rear housing.
conbread
04-09-2006, 07:24 PM
i had the brkt off the lower anyways.Just using it as a solid lower the car was ony driven 10 miles now i am redoing every thing and done my rear today and this is what i have come up with.So inow i need to get the fender off the tire.I will measure off a set of stock arms and see where it puts it. DO i measure center to center of bolt holes. thanks for the help.
p302stang
04-09-2006, 07:29 PM
yes center to center on the bolt holes
conbread
04-11-2006, 04:59 PM
I got the fender off the tire.I was in a hurry and forgot that i had a whole motor in the trunk besides the heads and block and had the car full of parts.But now the fender sits about 1 to 1 1.5 inches off the tire.when i install the anti rollbar will the fender still hit the tire on launch.And how much space does yalls car have. thanks for the info conbread
Z-MAN
04-14-2006, 02:51 PM
Maybe try some air bags in the springs to lift the rear off the tires????
Gray86hatch
04-14-2006, 03:17 PM
If you are running a radial and have the bar angles correct the car will stay neutral (not move up or down). A miss is as good as a mile.
I have less than 1/4" in some spots and have no rubbing at all.

Tim
zoop
04-14-2006, 07:53 PM
I got the fender off the tire.I was in a hurry and forgot that i had a whole motor in the trunk besides the heads and block and had the car full of parts.But now the fender sits about 1 to 1 1.5 inches off the tire.when i install the anti rollbar will the fender still hit the tire on launch.And how much space does yalls car have. thanks for the info conbread


LOL