fox roller w/cage

[1fastblue90lx]

send e mail addy to me at aggressive1@comcast.net from there, I will answer any added questions in the evening thru e mail. IF i see you are serious, I will then give u my cell number. AS a starting point, say it is a SHELL ONLY and I will tell u what it DOES HAVE. No need to keep asking 100 questions about things it does not have! THIS Is an excelllent foundation for a project car.It was prepared by a professonal mustang builder and he gave it up. Race, class, show or street. The car was purchased years ago from a friend. It has a clear title. It was ready for paint THEN but needs a once-over before it gets sprayed. It has k-200 primer on it. Simply clean the primer, wet sand and check for a ding or so and spray the paint. The engine bay has all the holes welded and filled.It has surface rust..needs wire wheel and metal prep, layer of filler and paint it. The door and trunk edeges are like new. they have small chips from handeling. The hood is of an 85. it is an HO fibertrends fiberglass. The car comes wit 87-93 style bumper covers and 85 rear. It has 87 style tail lights as well as 83 style which has a main power kill switch on it. The car has an 8.8 axle. I was told it has a 3.55 gear but do not know. The axle makes come clunking. I'm including another 3.55 gear and a factory posi with its components just in case.No fuel tank. Whole is cut @ tire well for fuel cell.The suspention is stock. CHASSIS: The rear torque boxes have been welded. There is a full roll cage with driver window net provisions. The frame is tied. The roll cage was done properly, NOT HACK WELDED.IT has added gussets for strength. The car needs (1) door window, front and rear glass. I DO have 85 style pillar glass inc. All the window trim should be there. It has all new weather stripping, and new carpet in the box. I believe all of the 85 interior panles are there. NO DASH! NO CONSEL. I was going to cut an 87-93 dash to fit.NO SEATING. ALL the panels are just resting on the car. I have a few boxes of fairly seperated parts, mounts, brackets and all the screws off the car. Use what you need. I do not think I have a wiring harness. He was going to try to save weight and run only the necessary wires.It comes with 4 cyl. and v 8 springs.The car is very clean rust wise. It needs brake lines. Standard brakes pake parts are included.It comes stock rollin' spare tires...ps. no radio..ha INCLUDED WITH THE CAR: set of RJS race seat belts, Electric fan, MSD 6a ignition, NEW in the box cross member, An AUTOMETER tach some nice gauges, a b&m "pro-stick" shifter-no cover....aluminum MOTOR PLATE IF you put it into pieces alone, without the roll cage, you would be at $1200.00 plus - parting it out completely. The roll cage alone is worth over $1,500.00
FIRST $1,300 takes it outta here