purstreetnewbie
02-10-2003, 08:58 AM
have a short block assembly, stock crank std./std. that has been nitride hardended. Eagle rods with foating pins, custom BRC pistons 405 grams no valve reliefs, 4.040 bore offset pin, coated top and sides, custom lightweigt writ pins from ferrea, 1.5mm 1.5mm, 3mm ring package, set of total seal gapless top ring for pistons, federal mougle main bearings coated 3/4 oil groove, clevite rod bearings, coated both are h-series. stock block decked for assembly to put piston 4 thou. out of hole. assembly is balanced. Bored and honed. Block is coated with anti stick inside. billit steel main girdle. Moroso oil pan with crank scraper. Custom comp cams camshft for pure street/street warior. austrailian muscleparts cam retainer with torrington bearings on both sides. nascar timing chain, set of TFS twisted wedge heads ported for engine. ferrea stainless valves comp cams 925 valve springs superlight titanium retainers. 1044-16 comp cams rocker arms, billit steel balancer (SFI approved) an accel dist for a carb car
make offers will entertain any reasonable offer,
will part out somewhat
(765)425-2668
creampuff_racer@hotmail.com
make offers will entertain any reasonable offer,
will part out somewhat
(765)425-2668
creampuff_racer@hotmail.com