514 into a 94 gt??

[fcfighter24]

I want to run a 514 and a blow through centrifugal blower in a 94 gt mustang. the problem is i have had absolutely no luck finding out if it fits. i know you can buy a race setup from skinny kid for like 5 grand but i was thinking a little bit more low budget. do you have to run a motor plate to run this motor or is there a k-member out there? and where do you find the brackets for a f1r? does everything have to be fabricated?

[bbfstanger]

itll fit but not much room for a blower,the brackets for the blower would have to be made or adapted,a motor plate is the easiest and roomiest way to put a bbf in a stang,you can use fox bbf headers,id recommend a tube kmember like aje or pa to help with the header clearance.
john

[cobra tom]

no prob on that swap, just use a 94/95 k-member for a 302 and some bb mounts for a fox, don't know about the brackets for the blower but the pan, headers and mounts should only cost you around $700. 00 gl

[SwillRacer]

I can price out a Team Z k-memb and BBF mounts for you if you're interested. Just PM me.

[NMRA Jason]

You guys do realize this thread is from April of 2007, right?

[Thriller8]

You guys do realize this thread is from April of 2007, right?

It's a slow process. haha