 |
|
|||||||
| Small Block Ford Discussion This is your forum to discuss small block Ford (5.0, & 351/Pushrod) Windsor engines. |
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
11-17-2007, 12:00 PM
|
||||
|
||||
|
Water/radiator fittings
Water/radiator fittings
I have a set of Yates heads that have the AN fitting in the front for the water passages. What are you guys using to adapt the heads to the radiator? And from where are you scoring it? 
|
|
#2
11-17-2007, 05:36 PM
|
|||
|
|||
|
Re: Water/radiator fittings
Go to this address and check it out. I have one on my car with yates heads and it work out great.
http://cgi.ebay.com/ebaymotors/NEW-F...spagenameZWDVW
|
|
#4
11-18-2007, 08:58 AM
|
||||
|
||||
|
Re: Water/radiator fittings
There are some adapters that go from hose to an style, or you could just have male an bungs welded to the radiator.
__________________
Drag Radial car in action www.CandCmotorsport.com www.XSRcylinderheads.com Email: Greg@xsrcylinderheads.com 
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Linear Mode
